Table of Contents
Advertisement
f The IP address setting mode is canceled when the <ENTER> button is pressed, and the settings are
displayed in the self-diagnosis display in two second intervals as follows. Next display is an example when
[IP ADDRESS] is set to 192.168.0.10.
"192"
Note
f The IP address setting mode is canceled when no setting operation is performed for 10 seconds or longer in the IP address setting mode.
f The IP address will be set to the following factory default setting when the <DEFAULT> button on the remote control is press while in the IP
address setting mode.
[DHCP]
[IP ADDRESS]
Control device password
To initialize your password, consult your distributor.
Upgrade Kit
If the optional Upgrade Kit (Model No.: ET-UK20) is applied, the following functions are extended.
Function
Adjustment range of
[VERTICAL KEYSTONE]
Adjustment range of
[HORIZONTAL KEYSTONE]
Adjustment range of
[CURVED CORRECTION]
Adjustment range of
[PINCUSHION]
[CUSTOM MASKING]
[FLEXIBLE CORRECTION] of
[UNIFORMITY]
*1 The adjustment range of the menu. Refer to "[GEOMETRY] projection range" (x page 47) for the possible projection range.
Chapter 7 Appendix — Technical information
"168"
OFF
192.168.0.8
Standard status
Maximum of ±40°
*1
Maximum of ±15°
*1
Vertical arc, Maximum ±50
*1
Horizontal arc, Maximum ±50
*1
Maximum of ±50
*1
Cannot be used.
Correction value for brightness unevenness and
color unevenness cannot be set.
"000"
"010"
When the Upgrade Kit is applied
Maximum of ±45°
Maximum of ±40°
Vertical arc, Maximum ±100
Horizontal arc, Maximum ±100
Maximum of ±100
The image is masked in optional form.
Correction value for brightness unevenness and
color unevenness can be set.
Display end
*1
*1
*1
*1
*1
ENGLISH - 257
Advertisement
Table of Contents
