Brother MFC5890CN Service Manual page 431

Selector
No.
1
PictBridge command delay time
2
Extension of the "No. of CNG
3 cycles to be detected" for Easy
Receive mode
Recovery of cordless handset ID
4
(Not used.)
5
Caller ID tone alert detection
period
6
Transmission of caller ID wetting
7
pulse
Switching between DTMF and
8
FSK for caller ID
Note: Selectors 1 and 2 are applicable to PictBridge-enabled models.
Note: Selector 4 is applicable to models with cordless handset.
Note: Selectors 5 through 7 are applicable to the UK models.
Note: Selector 8 is applicable to the Chinese models.
• Selectors 1 and 2: PictBridge command delay time
These selectors specify the PictBridge command delay time that applies when the machine
responds to the digital camera connected via PictBridge during negotiation. If the machine
fails to receive data from the digital camera, change the delay time.
• Selector 3: Extension of the "No. of CNG cycles to be detected" for Easy Receive mode
In Easy Receive mode, if the machine fails to detect the CNG even after the setting made
by selectors 4 and 5 on WSW26, extend the "No. of CNG cycles to be detected" by two
cycles.
• Selector 4: Recovery of cordless handset ID (Not used.)
Enabling this function automatically writes the cordless handset ID registered on the main
PCB onto the cordless PCB when the power is turned on if the ID on the cordless PCB is
discrepant with the one on the main PCB.
• Selectors 5 and 6: Caller ID tone alert detection period
If the machine misdetects a tone alert for a caller ID, adjust the detection period with these
selectors.
WSW54
(Function setting 19)
Function
App. 4-57
Setting and Specifications
No. 1 2
0 0 : 100 ms (default)
0 1 : 0 ms
1 0 : 50 ms
1 1 : 200 ms
0: No
0: Enable
No. 5 6
0 0 : 10 ms (default)
0 1 : 20 ms
1 0 : 30 ms
1 1 : 40 ms
0: Enable
(default)
0: DTMF
(default)
1: + 2 cycles
1: Disable
1: Disable
1: FSK
ms: millisecond(s)
Confidential