6.1.5
Control Panel ASSY
(1) Remove four screws from the control panel ASSY.
(2) Pull up the rear end of the control panel ASSY and turn it up slightly.
NOTE: Do not pull the control panel ASSY away from the machine since it is connected to
the machine with the panel-main harness.
(3) Hold the control panel ASSY at an angle of approx. 45° and slide it to the rear
approximately 10 mm to release the nine hooks from the upper cover. Then disconnect the
panel-main harness and LCD flat cable from the main PCB.
NOTE: After disconnecting the flat cable(s), check that each cable is not damaged at its
end or short-circuited. When connecting the flat cable(s), do not insert it at an angle. After
insertion, check again that it is not at an angle.
Control panel ASSY
Upper cover
Assembling Note: After mounting the control panel ASSY, check that there is no gap
between the front end of the control panel ASSY and that of the upper cover.
Panel-main harness
Main PCB
Taptite, cup B
M3x10
Ink cartridge cover
Speaker connector
6-25
Hooks
LCD flat cable
Panel-main connector
Battery connector
(6_28)
Confidential