Grizzly G0920 Owner's Manual page 22

Note: Pre-installed shoulder screws in
mounting blocks should face away from other
mounting block (see Figure 22).
Pre-Installed
Shoulder Screw
Figure 22. Mounting block installed correctly.
21. Repeat Step 20 with remaining table mount-
ing bracket.
22. Attach (2) table mounting brackets to table
frame under conveyor table with (8) M8-1.25
x 16 cap screws, 8mm lock washers, and
8mm flat washers (see Figure 23).
Conveyor Table
x 8
Figure 23. Table mounting bracket attached to
table frame.
-20-
Table
Mounting Bracket
(1 of 2)
23. Attach (2) right table folding brackets to right
mounting blocks as shown in Figure 24 with
(2) M10-1.5 x 65 shoulder screws, 10mm flat
washer, and M10-1.5 lock nut.
Right
Folding Bracket
Figure 24. Right table folding bracket installed.
24. Repeat Step 23 with (2) left table folding
brackets.
25. Attach (2) extension tables to folding brack-
ets with (8) M8-1.25 x 20 carriage bolts,
8mm flat washers, 8mm lock washers, and
M8-1.25 hex nuts (see Figure 25).
Extension Table
(1 of 2)
Folding Bracket
(1 of 4)
Figure 25. Extension tables installed.
Model G0920 (Mfd. Since 10/20)
Right
Mounting Block
x 2
x 8