Inventory - Grizzly G0920 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
A
E
I J
O P
-12-
B
F
K L
Q R
Figure 2. Cabinet inventory.
Cabinet (Figure 2)
A. Front Panel ................................................. 1
B. Rear Panel.................................................. 1
C. Left Side Panel ........................................... 1
D. Right Side Panel ......................................... 1
E. Bottom Panel .............................................. 1
F. Top Panel ................................................... 1
G. Rubber Feet ............................................... 4
H. Partition Panels .......................................... 2
I.
Slotted Screws ⁄
5
16
J.
Hex Bolts M8-1.25 x 40 .............................. 4
K. Hex Bolts M8-1.25 x 25 .............................. 8
L. Phillips Head Screws M5-.8 x 8 ............... 10
M. Fender Washers 8mm ................................ 4
N. Flat Washers
⁄ " ........................................ 4
5
16
O. Flat Washers 8mm ................................... 16
P.
Flat Washers 5mm ................................... 10
Q. Lock Washers 8mm.................................. 12
R. Lock Washers 5mm.................................... 4
S. Hex Nuts
⁄ "-18 ......................................... 4
5
16
T.
Hex Nuts M8-1.25 ....................................... 8
C
G
M
S
Model G0920 (Mfd. Since 10/20)
Qty
"-18 x ⁄ " ........................ 4
3
4
D
H
N
T