Table of Contents
Advertisement
26. Use
straightedge
table alignment with conveyor table (see
Figure 26).
Extension
Table
Straightedge
Figure 26. Checking extension table alignment.
— If straightedge is flat against conveyor
table and both extension tables, no adjust-
ment is required. If anchoring machine
to floor, proceed to Anchoring to Floor
on Page 22. Otherwise, proceed to Dust
Collection on Page 22.
— If straightedge is not flat against conveyor
table and both extension tables, proceed
to Step 27.
27. For extension table(s) not aligned to convey-
or table, loosen carriage bolts from Step 25,
adjust table until it is aligned with conveyor
table, and tighten bolts.
— If straightedge is flat against conveyor
table and both extension tables, no fur-
ther adjustment is required. If anchoring
machine to floor, proceed to Anchoring to
Floor on Page 22. Otherwise, proceed to
Dust Collection on Page 22.
Model G0920 (Mfd. Since 10/20)
to
check
extension
Conveyor
Table
— If straightedge is still not flat against con-
veyor table and both extension tables,
proceed to Step 28.
28. For extension table(s) not aligned to con-
veyor table, loosen cap screws from Step 22.
29. Adjust (2) set screws shown in Figure 27 until
extension table is even with conveyor table.
Figure 27. Location of table alignment set
screws.
30. Once both extension tables are even with
conveyor table, tighten cap screws from Step
22 to secure extension tables.
If anchoring machine to floor, proceed to
Anchoring to Floor on Page 22. Otherwise,
proceed to Dust Collection on Page 22.
-21-
Advertisement
Table of Contents
