Inventory - Grizzly T33256 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory (Figure 5)
A. Table ........................................................... 1
B. Miter Gauge ................................................ 1
C. Sanding Disc 6" 80-Grit ............................. 1
D. Work Stop ................................................... 1
E. Hex Wrenches 3, 5mm .........................1 Ea.
F. Open-End Wrench 14mm ........................... 1
G. Handle M6-1 x 15, 65L ............................... 1
H. Table Stud .................................................. 1
I. Wing Knobs M5-.8 x 14 .............................. 2
J. Mounting Brackets ...................................... 4
K. Cap Screws M6-1 x 16 ............................... 2
L. Flat Washers 6mm ..................................... 3
M. Lock Washers 6mm.................................... 2
Model T33256 (Mfd. Since 04/22)
A
D
Qty
G
J
L
B
E
H
M
Figure 5. Inventory.
C
F
I
K
-13-