Table of Contents
Advertisement
Inventory
After all the parts have been removed from the
two boxes, you should have the following items:
Box 1: (Figures 4, & 5)
A. Metalworking Sander .................................. 1
B. Spark Trap .................................................. 1
C. Rest ............................................................ 1
D. Eye Shield .................................................. 1
E. Angle Adjustment Lever ............................. 1
F.
Flat Washer 12mm ..................................... 1
G. Sleeve ......................................................... 1
H. Hex Nut M12-1.75 (Base) ............................ 1
I.
Fender Washers 12mm (Base) ................... 2
J.
Hex Bolt M12-1.75 X 150 (Base) ................. 1
A
C
B
Figure 4. Model G0489 Inventory.
G0489 Metalworking Sander
Qty
E
F
D
G
J
H
I
K. Base ........................................................... 1
K
Figure 5. Model G0489 Base.
In the event that any nonproprietary parts are
missing (e.g. a nut or a washer), we would be
glad to replace them, or for the sake of expedi-
ency, replacements can be obtained at your local
hardware store.
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed on the machine.
Check these locations before assuming that
any items from the inventory list are miss-
ing.
-11-
Advertisement
Table of Contents
