Grizzly G0574 Manual Insert

INTRODUCTION
The Model G0574 Radiusing Sander is based
on the Model G1140 Edge Sander with the
addition of the radiusing attachment. Refer to the
G1140 Edge Sander manual for the sanding unit
assembly instructions and refer to the included
G0577 Radiusing
radiusing attachment installation instructions. The
Model G0574 DOES NOT include the work table,
auxiliary table, and miter body listed in the manual
of the G1140. These parts are unnecessary
when the radiusing attachment is installed. The
inventory for the G0574 is as follows:
Model G0574 Parts:
• Sanding Unit ............................................... 1
• Quick Release Lever .................................. 1
• Dust Port .................................................... 1
• 6'' X 80'' Sanding Belt ................................ 1
• Back Stop ................................................... 1
• Feet ............................................................ 4
•
Long Support Bracket ................................ 1
•
Short Support Bracket ................................ 1
•
Guide Rail A ............................................... 2
•
Guide Rail B ............................................... 4
•
Radius Control Swing Arm Assembly ........ 1
•
Horizontal Adjustment Tubes ..................... 2
•
Locking Plate A .......................................... 2
•
Locking Plate B .......................................... 4
• Brace .......................................................... 1
• Height Adjustment Arms ............................ 2
• Idler Roller Cover ....................................... 1
When ordering parts for the Model G0574 Radiusing Sander, refer to the G1140 manual for sanding unit
components, and refer to the G0577 manual for radiusing attachment components.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
Attachment manual
COPYRIGHT © MAY, 2005. BY GRIZZLY INDUSTRIAL, INC.
#EW7254 PRINTED IN TAIWAN
MANUAL INSERT
Radiusing Sander
for
Model G0574 Hardware Bag:
—Shim ....................................................... 1
—Hex Bolt
—Hex Bolt
—Flat Washer
—Flat Washer
—Hex Nut
—Hex Bolt
—Hex Nut
— ⁄
7
—12-14mm Open End Wrench ................... 1
—2mm Hex Wrench ................................... 1
—Phillips
NOTICE
Model G0574
Figure 1. Model G0574.
⁄ "-18 x 2½" ............................. 3
5
16
⁄ "-16 x 1" ................................. 3
3
8
⁄ " ......................................11
3
8
⁄ " ...................................... 6
5
16
⁄ "-18 ....................................... 3
5
16
⁄ "-16 x 2 .................................. 2
3
8
⁄ "-16 ......................................... 2
3
8
" Hex Wrench ...................................... 1
32
Hd Screw 10-24 X 3/4'' ............. 4
®