Part 1: Fpga Development Board Introduction - Alinx ZYNQ7000 FPGA User Manual

Part 1: FPGA Development Board Introduction

The AX7450 FPGA development board is mainly composed of ZYNQ7100
main chip, 6 DDR3, 1 eMMC, 2 QSPI FLASH and some peripheral interfaces.
The ZYNQ7100 uses Xilinx's Zynq7000 series of chips, model number
XC7Z100-2FFG900. The ZYNQ7100 chip can be divided into Processor
System (PS) and Programmable Logic (PL). On the PS side of the ZYNQ7100
chip, there are two DDR3 chips and four DDR3 chips on the PL side. Each
DDR3 has a capacity of up to 512M bytes, enabling the ARM system and
FPGA system to independently process and store data. The 8GB eMMC
FLASH memory chip on the PS side and two 256Mb QSPI FLASH are used to
statically store ZYNQ's operating system, file system and user data.
The AX7450 FPGA development board expands its rich peripheral
interface, including one PCIex8 slot, one Gigabit Ethernet interfaces, one
USB2.0 OTG interfaces, one UART serial interface, one SD card interface, one
FMC expansion interface, two SMT interfaces, some keys and LEDs.
Figure 1-1 is the Schematic diagram of the entire FPGA development
boards:
5 / 54
ZYNQ FPGA Development Board AX7450 User Manual
Amazon Store: https://www.amazon.com/alinx