Husqvarna P 535HX Operator's Manual page 64

Symbol
48 V batteries
overcharged
48 V batteries re-
PTO button indi-
PTO button indi-
Parking brake in-
OPC indicator
Service indicator
Note:
The symbols and the positions of the symbols
on the display can be different between different models.
64
Shows on the
Name
display
The symbol
shows.
The symbol
shows.
serve
The symbol
shows.
cator
The symbol is
yellow.
The symbol
shows.
cator
The symbol
shows (red).
dicator
The symbol is
yellow.
The symbol is
red.
The symbol
shows.
The symbol is
white.
The symbol is
Fuel level
yellow.
The symbol is
red.
The symbol
shows.
®
Bluetooth
Cause / Action
The 48 V batteries are fully charged and no more charge
is accepted. For example when you go down a slope
when the 48 V batteries are fully charged. Start the hy-
brid drive to decrease the batteries level.
The hybrid mode is disabled and the 48 V batteries re-
serve is used (<20%). The 48 V batteries can only be
charged with the power supply. Do not use the product
and speak to your Husqvarna servicing dealer if this
symbol shows.
The PTO button is engaged. Refer to
Off) button on page 9 .
Incorrect start or stop procedure. Refer to
product on page 35 .
The PTO button is engaged but there is no drive to the
blades or other equipment. Refer to
Off) button on page 9 .
The manual parking brake is engaged.
The operator presence control (OPC) is engaged. For
example if the operator lifts from the seat. Refer to
ator presence control (OPC) on page 9 .
The seat microswitch is engaged and the PTO button is
engaged. The drive to the blades or other equipment
stops automatically. Refer to
Servicing is necessary. Speak to your Husqvarna servic-
ing dealer.
The fuel level is in the correct range.
The fuel level is low.
The fuel tank is empty.
®
A Bluetooth device is connected to the product.
PTO (Power Take-
To stop the
PTO (Power Take-
Oper-
Safety circuit on page 22 .
1591 - 005 - 20.05.2021