Husqvarna P 535HX Operator's Manual page 38

9. Remove the locking pin on the cutting height
adjustment lever in the top left corner of the cutting
deck.
10. Push the cutting height adjustment lever down and
pull the lever horizontally.
11. Put the lever in the hole with the same number as on
the adjustment plate.
Note:
Make sure the same number is selected on
all 3 adjustment points.
12. Attach the locking pin on the cutting height
adjustment lever.
13. Adjust the parallelism of the cutting deck. Refer to
adjust the parallelism of the cutting deck on page
57 .
To adjust the cutting height - Combi
155 X
1. Park the product on level ground.
2. Move the lever for the hydraulic lift arms forward to
lower the cutting deck to ground position.
3. Set the auxiliary power switch to position "1".
4. Move the lever for the auxiliary system forward and
rearward to adjust the cutting height.
Note:
The selected cutting height is shown with
the numbers 1-7 on the cutting deck. Refer to the
table below.
Number Cutting height, mm/in
1 30/1.2
38
Number
2
3
4
5
6
7
5. Adjust the parallelism of the cutting deck. Refer to
adjust the parallelism of the cutting deck on page
57 .
To adjust the cutting height - R180
1. Park the product on level ground.
2. Apply the parking brake.
3. Move the lever for the hydraulic lift arms rearward to
fully lift the cutting deck.
4. Turn the power key to the STOP position.
5. Remove the locking pin on the adjustment lever for
To
cutting height.
6. Lift the adjustment lever for cutting height and pull
the lever horizontally.
Note:
Refer to the table below for which cutting
height that agrees with which number.
Distance rings,
Number above/below
1 3xA+3xB/0
2 3xA+2xB/1xB
3 3xA+1xB/2xB
4 3xA/3xB
5 2xA/1xA+3xB
6 1xA/2xA+3xB
Cutting height, mm/in
40/1.6
52/2
64/2.5
76/2.3
93/3.7
112/4.4
Cutting height,
mm/in.
30/1.2
40/1.6
50/2.0
60/2.4
75/3.0
90/3.5
1591 - 005 - 20.05.2021
To