Husqvarna P 535HX Operator's Manual page 62

Problem
There is vibration in the product.
The cutting result is unsatisfacto-
ry.
The 48 V batteries does not
charge.
The 48 V batteries are too hot.
62
Cause
The blades are loose. Refer to
One or more of the blades are not balanced. Refer to
page 56 .
The engine is loose.
The bevel gear is loose.
There is an object in the PTO belt pulley.
The engine is defective.
The drive shaft is defective.
The vibration damping units and/or rubber connectors are worn out.
The blades are blunt or damaged. Refer to
The grass is long or wet. Refer to
The cutting deck is not parallel to the ground. Refer to
allelism of the cutting deck on page 57 and To do a check of the parallelism of
the cutting deck on page 58 .
There is grass blockage in the cutting deck. Refer to
page 46 .
The tire pressure is different on the right and left sides. Refer to
page 55 .
The pivoting wheels have different tire pressure on the right and left sides. Refer
to Technical data on page 67 .
The product is operated at too high speed. Refer to
on page 39 .
The engine speed is too low. Refer to
The belt tension is not correct.
The battery temperature is less than 0 °C.
The power supply is not correctly connected.
The connectors of the power supply are dirty or damaged.
The battery cooling system is dirty. Refer to
on page 47 .
The battery cooling fan is defective.
The batteries are dirty.
To examine the blades on page 56 .
To replace the blades on
To replace the blades on page 56 .
To get a good cutting result on page 39 .
To do a check of the par-
To clean the product on
To get a good cutting result
Technical data on page 67 .
To clean the battery cooling system
Tire pressure on
1591 - 005 - 20.05.2021