Husqvarna P 535HX Operator's Manual page 55

4. Do a check of the coolant level. Fill the coolant tank
if it is necessary. Refer to
67 .
5. Do a check of the coolant level in the expansion
tank. The level must be at the LOW mark when the
engine is cold.
Tire pressure
Technical data on page 67 for the correct tire
Refer to
pressure.
1591 - 005 - 20.05.2021
Technical data on page
Cutting deck - C132, C155
To put the cutting deck in servicing position
1. Do the procedure in
page 29 but do not disconnect the lift arms.
2. Remove the service stay from the cutting deck.
WARNING:
and the safety straps when the cutting
deck is in servicing position. To not use
the service stay or safety straps correctly
can result in serious injury or death.
3. Attach the service stay to the red point below the
bottom plate.
4. Pull the pin on the other end of the service stay.
Attach the service stay to the red mark on the pipe
on the cutting deck.
5. Start the engine.
6. Move the lever for the hydraulic lift arms rearward to
lift the cutting deck fully.
To remove the cutting deck on
Attach the service stay
55