Husqvarna P 535HX Operator's Manual page 41

Maintenance
Make sure that the hydraulic hoses and the hydraulic couplings are
clean and not damaged.
Do a check of the oil level in the hydraulic oil tank.
Replace the hydraulic oil filter.
Replace the hydraulic oil.
Engine
Make sure that the cold air intake of the engine is not blocked.
Do a check of the coolant level.
Replace the coolant.
Do a check of the engine oil level.
Replace the engine oil and oil filter.
Clean the air filter.
Replace the air filter.
Replace the primary fuel filter and pre-filter.
Replace the alternator belt.
Cutting deck
Clean the cutting deck, below the belt covers, and below the cutting
deck.
Examine the cutting deck for damages.
Examine the blades in the cutting deck. Refer to
blades on page 56 and To examine the blades on page 58 .
Replace the blades.
Examine the belt of the cutting deck for damages.
Replace the belt of the cutting deck.
Do a check of the oil and oil level in the bevel gear.
Replace the oil in the bevel gear.
Do a check of the parallelism of the cutting deck.
Wheels and transmissions
Examine and tighten the wheel nuts with the correct torque (84 Nm).
Make sure that the tire pressure is correct (1.5 bar).
Replace the oil in the transmissions.
Do a check of the oil in the transmissions. Clean the magnetic plug,
if applicable.
1591 - 005 - 20.05.2021
Daily
To examine the
First Maintenance interval
Wee
50
kly
hours
200
*
X
X
*
*
X
X
X
X
X
X
*
X
*
X
in hours
400 800
*
X
X
O
X
X
X
X
O
X
*
X
*
X
X
*
O
O
41