Husqvarna P 535HX Operator's Manual page 54

6. Use a funnel to fill the hydraulic oil into the opening.
Fill until the level is at the lower edge of the sight
glass.
7. Install the lid, the side hose and the covers in
opposite sequence.
To drain the hydraulic system
1. Remove the service lid. Refer to
service lid on page 48
2. Remove the right side cover. Refer to
right side cover on page 48 .
3. Open the lid for the hydraulic system. Refer to
the hydraulic system on page 53 .
4. Remove the drain plug and drain the hydraulic oil.
5. Install the lid, drain plug and covers in opposite
sequence.
To replace the hydraulic oil filter
1. Drain the hydraulic system. Refer to
hydraulic system on page 54 .
54
To remove the
To remove the
To fill
To drain the
2. Turn the hydraulic oil filter counterclockwise to
remove it.
3. Apply new oil to the rubber gasket on the new oil
filter.
4. Install the new hydraulic oil filter. Tighten by hand.
5. Fill the hydraulic system. Refer to
system on page 53 .
To adjust the PTO-belts
1. Release the lock nut (A).
2. Tighten the adjustment screw (B) until the sleeve (C)
cannot be rotated by hand.
3. Hold the adjustment screw (B) and tighten the lock
nut (A).
A
C
To do a check of the coolant level
1. Park the product on level ground and stop the
engine.
2. Open the engine cover. Refer to
remove the engine cover on page 48 .
3. Open the coolant cap.
To fill the hydraulic
B
To open and
1591 - 005 - 20.05.2021