When Used In Conjunction With Smartstart; D2D Port Configuration; Module Programming - Directed DIRECTECHS DS4+ Installation Manual

When used in conjunction with SmartStart

To enable D2D communication between the DS4+ and the SmartStart one of the following actions must be executed:
SmartStart with Loops – The brown loop must be cut.
•
SmartStart with Pigtails – The gray wire must be connected to a ground source.
•
Loops
DO NOT connect the SmartStart 2-pin power harness when using the DS4+. Power and ground will be provided by the D2D
connector on main module. Refer to the SmartStart documentation for further details.

D2D port configuration

The system will automatically configure the D2D ports based on your selections in the module programming. The white D2D port is
reserved for SmartStart. To ensure proper functionality with SmartStart, it is important that it is selected in the system programming
of the DirectLink application or via the online web tool.
Note: Both black D2D ports are reserved for the Control Center (antenna) and 8504D Combo Sensor.

Module programming

Refer to "LED diagnostics and troubleshooting" on page 23 for more information and for troubleshooting purposes.
To connect the module:
Please ensure that the vehicle is in a safe location and cannot move forward during
1
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
2
Connect all the harnesses to the DS4+, EXCEPT the 12-pin main power harness.
Connect the 12-pin main power harness, and wait until the LED turns ON solid red.
3
Note: To skip the transponder programming and use convenience features only press the
programming button 5 times. The LED will turn orange then proceed to step 4.
Press on the brake and then press the Push-to-Start button in order to start the vehicle.
The LED flashes green quickly then orange quickly.
4
NOTE: If the transponder programming was skipped, the LED turns ON solid orange
for 3 seconds then shuts off once the module is successfully programmed without
bypass. Press the PTS button once to switch the vehicle OFF and proceed to step 8.
Remove the module from the vehicle and reconnect it to your computer. The Directechs
5
web site will automatically recognize that you are moving on to the second phase of the
programming sequence.
6
Select the method and click on Submit Key2GO Request.
22
Pigtails
Connect all but the
12-pin harness
Must be
connected LAST
&
& & &
Flashes
green
quickly
&
Solid
x 3 secs
DS4+ SUBARU3
© 2017-09-26 Directed. All rights reserved.
Solid
Flashes
orange
quickly
OR
Off