MACHINE OVERVIEW
Toner Save Button
This LED goes on and the toner save mode gets enabled when you press
the cancel button 0.5 sec. The LED goes off and toner save mode gets
disabled when you press the cancel button again.
On Line/Error Button and Toner Save Button
The machine experiences internal problems if On Line/Error and Toner Save
button LEDs blink at the same time.
Cancel Button
The cancel button lets you do the following functions.
Print demo page: In Ready mode press and hold this button for about 2
1.
seconds until all LEDs blink slowly. Then release the button.
Print configuration page: In Ready mode press and hold this button for about 6
2.
seconds until all LEDs blink quickly. Then release the button.
Clean inside of the printer: In Ready mode press and hold this button for about
3.
10 seconds until all LEDs turn on. Then release the button. The machine prints
one cleaning sheet after this procedure.
Cancel a print job: Press this button during printing. The On Line/Error LED
4.
blinks while the print job gets cleared from both the printer and the computer.
Then the machine goes back Ready mode. This may take some time
depending on the size of the print job. You cannot do this procedure in Manual
Feed mode.
5. Toner save mode on/off: In Ready mode, press this button to turn the Toner
Save mode on or off (about 0.5sec).
6-4
20 July 2005