Table of Contents
Advertisement
20 July 2005
3. REPLACEMENT AND ADJUSTMENT
This manual uses the following symbols.
: See or refer to : Screw : Connector: : C-clamp (snap ring)
clamp
3.1 GENERAL PRECAUTIONS
• Use high caution when you disassemble and reassemble components.
• Make sure all cables are correctly routed. Check the correct cable routing before
you service the machine. Return all cables to their original position after you
service the machine.
3.1.1 SERVICING THE MACHINE
1. Make sure there are not documents stored in memory before you service the
machine.
2. Remove the toner cartridge before you disassemble parts.
3. Unplug the power cord before you service the machine.
4. Use a flat clean surface to service the machine.
5. Use only approved replacement parts. Machine function cannot be guaranteed
of you use unauthorized replacement parts.
6. Do not force plastic components.
7. Make sure all components are in their correct positions..
3.1.2 RELEASING PLASTIC LATCHES
Many of the parts are held in place with
plastic latches. The latches break easily.
Release them carefully. To remove such
parts, press the hook end of the latch away
from the part to which it is latched
.
3-1
GENERAL PRECAUTIONS
G144R001.WMF
: E-
Advertisement
Table of Contents
