Table of Contents
Advertisement
Description and Operation
4.1.7
Control displays
Oil pressure control
Battery control
Temperature control
Pre-heat
Fuse box
Horn/Reset – driving (safety
seat switch)
(12)
Hour
meter
(15)
5150.0022+5150.0023 (41500820)
The oil control light (12) has to be illuminated when the ignition (13) is on step 1.
The light must not be illuminated when the motor is running.
The battery control light (14) has to be illuminated when the ignition (13) is on step
1. The light must not be illuminated when the motor is running.
If the water temperature control display (15) is in the red section, the air filter has
to be cleaned or renewed. The cooling fins of the radiator have to be cleaned with
compressed air and the cooling water has to be checked.
If the temperature control display is still in the red section please contact a
qualified workshop.
Turn ignition to step II until the pre-heat control display (17) is illuminated After a
short time (approx. 25 sec.) the pre-heat control display has to stop the
illumination. This means that the engine can be started now by turning the ignition
to step III
The fuse box is behind the covering of the control displays. For changing fuses
remove the fixing bolts at the control-displays covering.
Button for horn / reset button:
Press reset button each time for the driving, when the machine will be started and
when the driving was stopped caused by the standing up of the diver from the
driver´s seat (triggered by the seat switch).
The reset button only works, when the driver is sitting on the s seat.
(14)
light
Horn/Reset driving
(17)
Turn signal indicator
V3
18 / 36
(13)
Fuse box
GB
Advertisement
Table of Contents
