Fixing Of Attachments; Transportation Of The Vm-301-Pavermax - probst VM-301-K-PAVERMAX Operating Instructions Manual

Description and Operation
●
Drive with load (stone slab) carefully to the place of
destination.
● Lower the load (with the left foot pedal  Fig. B).
●
Place the load on the floor and move the joystick fprward
(vacuum is interrupted).
●
Immediately move the lifting arm upwards. Otherwise,
after the joystick has been released (in middle position), the
vacuum operation is immediately active again!

Switch off the vacuum  press the blue button on the
joystick.
4.4

Fixing of attachments

●
Different attachments (HVZ/-uni) can be mechanically fixed to the lifting arm
●
For the hydraulic operation there are two different hydraulic circuits available.
yellow marking
ring (to HVZ
main clamping)
black marking
ring (to HVZ
main clamping)
Hydraulic line
to rotator
4.5

Transportation of the VM-301-PAVERMAX


Lifting equipment is not essentially required. The VM-301-
PAVERMAX can be driven to the trailer or the truck by using
suitable planks.

Just use proper planks, be aware of the different track
width on front and rear!

For transportation the hand break has to be tightened and
the VM has to be secured additionally to avoid shifting and
rolling to correspond with the regulations.

For fixation in front and rear there are two eyebolts (30)
fixed to the VM.
5150.0022+5150.0023 (41500820)
Fig. A
(30)
V3
21 / 36
Fig. B
Red marking
ring (to HVZ
side clamping)
blue
marking ring
(to HVZ side
clamping)
GB