Table of Contents
Advertisement
Maintenance and care
To disconnect the electric system from the battery, the main switch must be activated at the VM-301-PAVERMAX at the right hand side and at the VM
204 at the left hand side of the engine under the hood. At about the same place, there is a lock to be pulled out to unlock the cover, where the seat is
fixed to.
At welding the battery main switch must be switched off general. Otherwise the electronic could be damaged!
Daily check before starting: Engine oil level, coolant, antifreeze, mater level hydraulic fluid level, battery, "V" belt tension.
The claim under guarantee for this device only exists and is subject to the proper execution of the
mandatory maintenance works (see attached booklet proof of maintenance)!
(In case of warranty request please always attach a copy of the proof of maintenance)
5.4
Recharching of the battery
●
Open engine cover by pulling the handle and tip the
motor hood backwards (Figure 1)
Figure 1
Figure 3
5150.0022+5150.0023 (41500820)
Unlock lever to lift
up driver´s seat
V3
●
Unlock the lever (see ) to lift up the drivers seat
(right hand at the rear in the engine compartment)
to arrive to the battery (Figure 2 and 3).
Figure 2
●
Before fold the driver´s seat upwards, remove the
rear window at the left (in direction of traffic), if
available.
●
Fold the driver´s seat upwards - carefully avoiding
danger of injury! Now the battery can be recharged.
Battery
Figure 4
28 / 36
GB
Advertisement
Table of Contents
