Shift Lever - Can-Am 219 002 095 Operator's Manual

CONTROLS
The brake pedal function is to slow
down or stop the vehicle.
When the brake pedal is pressed
down, only the rear brake is applied.
Braking effect is proportional to the
force applied on the pedal.
NOTE: The brake will have also an ef-
fect on front wheels through the drive
train when 4WD is engaged.

5) Shift Lever

The shift lever is located on the RH side
of the vehicle near steering column.
vmo2013-011-003
SHIFT LEVER LOCATION
The shift lever is used to change the
gearbox position.
The shift lever has 5 positions:
SHIFT LEVER POSITIONS
POSITION
P
R
N
H
L
______________
74
GEAR
Park
Reverse
Neutral
High range (forward)
Low range (forward)
vmo2012-012-036
SHIFT PATTERN
The vehicle must be stopped and
brakes applied prior to selecting any
gear.
NOTICE
This gearbox is not de-
signed to shift while vehicle is mov-
ing.
P: Park
The park position locks the gearbox to
help prevent vehicle movement.
WARNING
Always use the PARK (P) position
when the vehicle is not in oper-
ation. The vehicle can roll if the
shift lever is not set to P (PARK).
R: Reverse
The reverse position allows the vehicle
to go backwards.
NOTE: In reverse operation, the en-
gine's RPM is limited, thus limiting the
vehicle reverse speed.
WARNING
When driving downhill in reverse,
gravity can increase the vehicle
speed above the set limited re-
verse speed.
Neutral
The neutral position disengages the
gearbox.