Table of Contents
Advertisement
Technical Manual
11. Ensure the plastic washer (a) if fitted is placed correctly
over the input shaft (long side) as shown.
Re-assemble the front and rear brewer panels to the
central piston chamber/swing arms assembly using the
three retaining screws/locknuts. Check and ensure that
the brewer release lever mechanism operates
correctly.
c
b
13. Take the new filter head assembly from the service kit.
Holding the new filter assembly as shown, turn the
locking ring anti-clockwise to its open position,
indicated by the two arrows.
Place the filter unit up into the filter holder and turn the
green locking ring clockwise to lock it into place
e
12. Re-fit the brewer drive coupling to the input shaft
ensuring that the raised 'pip' (b) lines up with its locating
dimple (c) on the input shaft.
Ensure that the captive lock nut is retained in the plastic
drive coupling moulding. Refit the bolt to secure the
brewer drive coupling to the input shaft.
d
14. Re-assemble the wiper arm (d) to the filter holder
assembly.
Ensure that the wiper arm is located under the coffee
outlet pipes as shown (e).
131
Advertisement
Table of Contents
