I/O Configuration - HMS Anybus EtherNet/IP How To Configure

How to configure an EtherNetIP adapter with RSLogix 5000.doc
SCM-7032-029
Rev 2.03
5.2.

I/O configuration

The Anybus product has to be configured for the same I/O sizes as set up in the PLC configuration. The
configuration procedure is depending on the type of module. See the notes below.
Note: The I/O sizes are depending on the application, the configured I/O sizes in this chapter are just
examples.
Note for the Anybus-S Slave Interface and the Anybus PCI card:
The Anybus Slave Interface and the Anybus PCI card are configured by the host application interface. Refer
to the Fieldbus Appendix for details.
Note for the Anybus CompactCom and the Anybus-IC:
The Anybus CompactCom and the Anybus-IC are configured by messages sent by the application. Refer to
the Anybus-IC Fieldbus Appendix and the Anybus CompactCom Network Interface Appendix for details.
Note for the Anybus Communicator and the Anybus X-gateway:
The configuration of the Anybus Communicator and the Anybus X-gateway is described in separate sections
below.
Saved: 2008-03-05 HMS Industrial Networks AB Page 15 (20)
Filename: How to configure an EtherNetIP adapter with RSLogix 5000.doc