Table 2-7
Table 2-7 2487 Detector Connections to a busSAT/IN Module
2
2.7.2 Connecting the 2487 Detector to a 745/745B/746 Data Module
You can connect the 2487 Detector to a Waters 745/745B/746 Data Module using the
analog output connector on the rear panel of the detector. The analog connector provides
both 2 V and 10 mV outputs which are scaled to the AUFS sensitivity setting and the
voltage offset setting.
Attention:
STOP
745/745B/746 integrator, do not exceed the input voltage rating of the integrator.
To send the analog output signal from the 2487 Detector to the Waters 745/745B/746
Data Module, use the cable provided in the 2487 Detector Startup Kit to make the
connections summarized in
68
Installing the 2487 Detector
summarizes the 2487 Detector connections to the busSAT/IN Module.
2487 Detector
(B Inputs and Outputs)
Pin 1 ChA 2 V (white)
Pin 3 ChA Ground (black)
Pin 5 ChB 2 V (white)
Pin 7 ChB Ground (black)
To prevent oversaturation of the signal from the 2487 Detector to the
Table 2-8
busSAT/IN
Connector
Channel 1 or 2
Channel 1 or 2
and illustrated in
Figure
2-17.