Cypress PSoC 64 Secure Boot Manual page 29

Note: The entrance exam can be run separately without provisioning to verify the lifecycle stage
of a device by using the following command:
cysecuretools --target cyb06xx5 --policy ./policy/
policy_single_CM0_CM4.json entrance-exam
Note: In case you have a kit which has already been provisioned in the past with different
credentials, you can re-provision the chip with new keys & policies by running the below
command. Re-provisioning is possible if the policy provisioned into the chip allows this, by default
all policies provided in "CySecureTools" allow re-provisioning. Note that the Entrance Exam is not
run during a re-provisioning process.
cysecuretools --target cyb06xx5 --policy ./policy/
policy_single_CM0_CM4.json re-provision-device
CY8CPROTO-064B0S3 PSoC 64 "Secure Boot" Prototyping Kit Guide, Doc. # 002-29505 Rev. *B
Running Code on PSoC 64 "Secure Boot" MCUs
28