Powering Up The Router; Power-Up And Initialization; Initializing And Provisioning - Alcatel-Lucent 7705 Installation Manual

Initializing and Provisioning

Powering Up the Router

Complete the steps in
proceeding with the following instructions. Then power up the system and verify the LED
activity of all components.
The primary copy of the 7705 SAR-F TiMOS software is located on the compact flash
memory device that is factory-installed. The compact flash device is not user-accessible or
field-replaceable.
Notes:
•
•
•

Power-Up and Initialization

To power up the router, follow these steps:
Step 1.
Step 2.
Page 92
Wiring the DC Inputs on page 71
The DC-powered 7705 SAR-F does not have a power switch or circuit breaker. The
system is powered on by applying power from the DC power source. Typically, this is
done via a circuit breaker or a disconnect device.
Configurations and executable software can be stored on the compact flash memory
device or at an FTP file location.
You must have a console or Telnet connection to communicate with and provision the
Establishing Router Management Connections on page 95
7705 SAR-F. See
Turn ON the power to the router at the remote DC power source(s) to initiate the boot
process.
The Power LED should be blue, and the Bat A and Bat B LEDs should be green. If
only one DC power source is used, only one Bat LED should be lit.
Verify that the system is initializing.
The system searches the compact flash device for the
the bootstrap or boot loader file). The Status and Activity LEDs blink green during
initialization. After initialization (approximately 30 seconds), the Status and Activity
LEDs turn solid green.
If the LEDs do not operate as described above, or if they blink and turn off, refer to
Troubleshooting Initial Startup on page
and SFPs on page 75
boot.ldr
93.
7705 SAR-F Installation Guide
before
.
file (also known as