Powering Up The Router; Power-Up And Initialization - Alcatel-Lucent 7705 Installation Manual

Powering Up the Router

Powering Up the Router

Complete the steps in
page 83
verify the LED activity of all components.
The primary copy of the 7705 SAR-8 TiMOS software is located on the compact flash
memory device that is factory-installed on the CSM. The compact flash device is not field-
replaceable.
Note:
•
•
•
•

Power-Up and Initialization

To power up the router, follow these steps:
Step 1.
Step 2.
Page 102
Wiring the DC Inputs on page 79
before proceeding with the following instructions. Then power up the system and
The DC-powered 7705 SAR-8 does not have a power switch or circuit breaker. The
system is powered on by applying power from the DC power source. Typically, this is
done via a circuit breaker or a disconnect device.
Configurations and executable images can be stored on the compact flash memory
device or an FTP file location.
For proper thermal operation, ensure that slot covers are installed on all empty slots
before powering up the router.
You must have a console or Telnet connection to communicate with and provision the
Establishing Router Management Connections on page 105
7705 SAR-8. See
Turn on the power to the router at the remote DC power source(s) to initiate the boot
process.
The Power LEDs on the CSM and adapter cards should be blue and the Batt A, Batt
B, and Fan LEDs on the Fan module should be green. If only one DC power source
is used, only one Batt LED should be lit.
Verify that the system is initializing.
The system searches the compact flash device on the CSM (cf3) for the
file (also known as the bootstrap or boot loader file). The Status and Activity LEDs
on the CSM blink green during initialization. After initialization (approximately 30
seconds), the Status LED and the Activity LED on the active CSM turn solid green;
the Activity LED on the inactive CSM continues to blink green.
If the LEDS do not operate as described above, or if they blink and turn off, refer to
Troubleshooting Initial Startup on page
and Installing the Components on
103.
7705 SAR-8 Installation Guide
.
boot.ldr