Provisioning The 7705 Sar-F - Alcatel-Lucent 7705 Installation Manual

Initializing and Provisioning

Provisioning the 7705 SAR-F

The 7705 SAR-F does not require provisioning at the card or MDA levels because it is
provisioned at the factory with the following permanent configuration:
The following CLI display shows the factory-provisioned settings when the
command is issued.
ALA-12#show card
===============================================================================
Card State
===============================================================================
Slot/
Id
-------------------------------------------------------------------------------
1
1/1
1/2
A
===============================================================================
ALA-12#
Example
The CLI display for the example above when the
the following:
ALU-1>config# info
. . .
----------------------------------------------
echo "Card Configuration"
#---------------------------------------------
----------------------------------------------
ALU-1>config#
Page 98
• card type in slot 1 is
• mda type in slot 1/1 is
• mda type in slot 1/2 is
Provisioned Equipped
Type Type
iom-1g iom-1g
a16-chds1v2 a16-chds1v2
a8-ethv3 a8-ethv3
csm-1g csm-1g
card 1
card-type iom-1g
mda 1
mda-type a16-chds1v2
exit
mda 2
mda-type a8-ethv3
exit
exit
with
csm-1g iom-1g
(for T1/E1 ports)
a16-chds1v2
(for Ethernet ports)
a8-ethv3
Admin Operational
State State
up up
up up
up up
up up
info
7705 SAR-F Installation Guide
show card
Num Num Comments
Ports MDA
2
16
8
Active
command is issued looks similar to