Powering Up The Router; Power-Up And Initialization - Alcatel-Lucent 7705 Installation Manual

Powering Up the Router

Powering Up the Router
Complete the steps in
Inputs
power-up and initialization instructions.
The primary copy of the 7705 SAR-M TiMOS software is located on the compact flash
memory device that is factory-installed. The compact flash device is accessible via an access
cover that is positioned on the left side of the rear chassis plate. Accessing the compact flash
device facilitates the commissioning process as the device can be installed pre-programmed
with the desired software and configuration files.

Power-Up and Initialization

To power up the router, follow these steps:
Step 1. Turn ON the power to the router at the remote DC power source(s) to initiate the
132
Wiring the DC Inputs
for systems using an AC power source) and
Caution:
• Only qualified installers following ESD practices should access the compact flash
device.
• All power to the chassis must be disconnected while attempting to access the compact
flash device.
• The access cover must be fully secured in place before power is applied to the chassis.
Note:
• The 7705 SAR-M does not have a power switch or circuit breaker. The system is
powered on by applying power from the AC or DC power source. For AC power
supplies, unplug the cord(s) to disconnect the system from the power supply. For DC
power supplies, use a circuit breaker or a disconnect device to disconnect the system
from the power supply.
• Configurations and executable software can be stored on the compact flash memory
device or at an FTP file location.
• You must have a console or Telnet connection to communicate with and provision the
7705 SAR-M. See
boot process. For systems using AC power, plug the AC power converter into an
AC power source to initiate the boot process.
The logo should illuminate, and the Batt A and Batt B LEDs should be green. If
only one DC power source is used, only one Batt LED should be lit.
(or
Establishing Router Management
7705 SAR-M Chassis Installation Guide
Wiring the AC Power Converter to the DC
SFPs before proceeding with the
Connections.