Alcatel-Lucent 7705 Installation Manual page 105

Table 20: 7705 SAR-F Connector and LED Descriptions (Continued)
Key Label/Part
10 Ethernet Ports
11 +BattA/-BattA
+BattB/-BattB
12 Batt A
Batt B
13 Anti-static
Wrist Strap
Connector
14 Chassis
Ground Stud
7705 SAR-F Installation Guide
Sub Description
category
RJ-45 Six Ethernet ports have an RJ-45 connector for attaching user devices.
connectors The RJ-45 port number (1 through 6) is displayed below the port,
between the Link and the Act(ivity) silkscreen labels.
Link LED Green: Indicates that the link is up
Unlit: Indicates that there is no link, or that the link is operationally
down, disabled or shut down
Act LED Amber (blinking): Indicates that the port is active (receiving or
transmitting)
Unlit: Indicates that the port is down or disabled
SFP Two Ethernet ports have receptacles for SFP modules. The SFP port
connectors number (7 or 8) is displayed below the port. The associated Link and
Act(ivity) LEDs are located above the port.
Link LED Green: Indicates that a valid communication link has been established
Unlit: Indicates that the link is disabled or shut down, or that the SFP
optics are installed but no link is present, or that there is no SFP
installed
Act LED Amber (blinking): Indicates that the port is active (receiving or
transmitting)
Unlit: Indicates that there is no port activity
Connector The power connector is a standard terminal block with dual power feeds
for redundant DC supplies.
LEDs Green: Indicates that DC input power is present and operational.
Unlit: Indicates that the DC power supply is not installed or the DC
power feed is not connected
Note: The Batt A and Batt B LEDs are not affected by a Lamp Test
Connector The wrist-strap connector is a banana jack that provides a grounding
point for personnel working on the 7705 SAR-F.
Threaded The chassis ground stud allows a direct connection to the building
stud ground for the chassis ground point.
Appendix A: 7705 SAR-F Connectors and LEDs
Page 105