Alcatel-Lucent 7705 Installation Manual page 104

Appendix A: 7705 SAR-F Connectors and LEDs
Table 20: 7705 SAR-F Connector and LED Descriptions (Continued)
Key Label/Part
6 Mgmt Port
7 Console
8 Sync
9 T1/E1 Ports
Page 104
Sub Description
category
Connector The Ethernet Management port has an RJ-45 connector and is used for
the initial system startup as well as system configuration and
monitoring. It supports both half and full duplex modes and 10M/100M
or autonegotiated communication.
Refer to Management Port on page 108
LEDs The Link LED is located in the top left corner of the port and the
Activity LED is located in the top right corner.
Link Amber (blinking): Indicates that the Ethernet link has Rx/Tx activity
Unlit: Indicates that the Ethernet link has no activity, or is down or
disabled
Act(ivity) Green: Indicates that there is a valid communications link
Unlit: Indicates that there is no communications link, or that the link is
operationally down or disabled or shut down
Note: The Activity LED is not affected by a Lamp Test
Connector The console port has a DB9 male connector and is used for the initial
system startup as well as system configuration and monitoring. The
console port is a Universal Asynchronous Receiver/Transmitter
(UART) port. Refer to
assignments.
Use an EIA/TIA-232 DTE console cable to connect a terminal to the
console port. The factory default baud rate is 115.2 KBaud and can be
reconfigured for 9.6, 19.2, 38.4, or 57.6 KBaud.
In The "In" synchronization port has a 1.0/2.3 coaxial connector that can
be used to receive an external synchronization input signal.
Out The "Out" synchronization port has a 1.0/2.3 coaxial connector that can
be used to provide an external synchronization output signal.
RJ-45 Each T1/E1 port has an RJ-45 connector for attaching user devices.
connectors
Note: the yellow LED in the top right corner of the connector is not
used and is always off.
Stat LED Green: Indicates that a valid communication link has been established
Amber (blinking): Indicates that a loopback is in progress
Amber (solid): Indicates that there is no link present (administratively
up but there is an alarm)
Unlit: Indicates that the port is disabled or shut down
for pinout assignments.
Console Port on page 109
7705 SAR-F Installation Guide
for pinout