Daikin SkyAir RZR-TA Series Service Manual page 95

Cooling only 60 hz, heat pump 60 hz
Hide thumbs Also See for SkyAir RZR-TA Series:
Table of Contents

Advertisement

SiUS281811EA
DISPLAY "
1
This lights up when a signal is being transmitted.
DISPLAY "
2
(OPERATION MODE)
This display shows the current OPERATION MODE.
H
DISPLAY "
3
This display shows the set temperature.
DISPLAY "
hr.
4
This display shows PROGRAMMED TIME of the sys-
tem start or stop.
5
DISPLAY "
DISPLAY "
6
This display shows the set fan speed.
DISPLAY "
TION)
7
When the INSPECTION/TEST OPERATION BUTTON
is pressed, the display shows the system mode is in.
ON/OFF BUTTON
8
Press the button and the system will start. Press the
button again and the system will stop.
FAN SPEED CONTROL BUTTON
9
Press this button to select the fan speed, HIGH or LOW,
of your choice.
TEMPERATURE SETTING BUTTON
Use this button for SETTING TEMPERATURE.
10
(Operates with the front cover of the remote controller
closed.)
Part 3 Remote Controller
" " I " (SIGNAL TRANSMISSION)
" "
" "
" "
" "
"
M
L
" (SET TEMPERATURE)
F
" (PROGRAMMED TIME)
hr.
" (AIR FLOW FLAP)
" "
" (FAN SPEED)
" (INSPECTION/ TEST OPERA-
TEST
PROGRAMMING TIMER BUTTON
Use this button for programming "START and/or STOP"
11
time. (Operates with the front cover of the remote con-
troller opened.)
12 TIMER MODE START/STOP BUTTON
13 TIMER RESERVE/CANCEL BUTTON
14 AIR FLOW DIRECTION ADJUST BUTTON
OPERATION MODE SELECTOR BUTTON
15
Press this button to select OPERATION MODE.
FILTER SIGN RESET BUTTON
16
Refer to the section of MAINTENANCE in the operation
manual attached to the indoor unit.
INSPECTION/TEST OPERATION BUTTON
17
This button is pressed for inspection or test operation.
Do not use for normal operation.
EMERGENCY OPERATION SWITCH
18
This switch is readily used if the remote controller does
not work.
RECEIVER
19
This receives the signals from the remote controller.
OPERATING INDICATOR LAMP (Red)
20
This lamp stays lit while the air conditioner runs.
It flashes when the unit is in trouble.
TIMER INDICATOR LAMP (Green)
21
This lamp stays lit while the timer is set.
AIR FILTER CLEANING TIME INDICATOR LAMP (Red)
22
Lights up when it is time to clean the air filter.
DEFROST LAMP (Orange)
23
Lights up when the defrosting operation has started.
(For cooling only type this lamp does not turn on.)
Names and Functions
89

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents