Daikin SkyAir RZR-TA Series Service Manual page 167

SiUS281811EA
1.5.16 Airflow Setting when Heating Thermostat is OFF
This setting is used to set airflow when heating thermostat is OFF.
∗ When thermostat OFF airflow volume up mode is used, careful consideration is required before
deciding installation location.
1.5.17 Automatic Mode Differential
This setting makes it possible to change differential values for mode selection while in automatic
operation mode, only when the wireless remote controller or any central remote controller is
connected.
Mode No.
The automatic operation mode setting is made by the use of the "Operation Mode Selector" button.
1.5.18 Auto Restart after Power Failure
Mode
12 (22)
When the "Auto Restart after Power Failure" setting is turned OFF, all the units will remain OFF
after power failure, or after the main power supply is restored. When this setting is turned ON
(factory setting), the units that were operating before the power failure will automatically restart
operation after power failure, or after the main power supply is restored.
Due to the aforementioned, when the "Auto restart after power failure" setting is ON, be careful for
the following situations that may occur.
1. The air conditioner will start operation suddenly after power failure,
Caution
2. During maintenance, if the main power supply is turned OFF while the
1.5.19 Airflow Setting when Cooling Thermostat is OFF
This is used to set airflow to LL airflow when cooling thermostat is OFF.
Mode
12 (22)
Part 5 Field Settings and Test Operation
Mode No. First Code No.
12 (22) 3
First Code
No.
01
0°C
12 (22) 4
(0°F)
First Code Second
No. No. Code No.
01
5
02
or when the main power supply is restored. The user might be surprised
and wonder why the air conditioner turned ON suddenly.
units are in operation, the units will automatically start operation
(the fan will rotate) after the power supply is restored due to completion
of the maintenance work.
First Code Second Code
No. No. No.
01
6 02
03
Second Code No.
01
02
03
Second Code No.
02 03 04
1°C 2°C 3°C
(1.8°F) (3.6°F) (5.4°F)
Set fan speed
Field Setting from Remote Controller
: Factory setting
Contents
LL tap
Set fan speed
OFF
: Factory setting
05 06 07
4°C 5°C 6°C
(7.2°F) (9°F) (10.8°F)
: Factory setting
Contents
OFF
ON
: Factory setting
Contents
LL tap
OFF
08
7°C
(12.6°F)
161