Optional Wall Thermostat Installation - Regency Bellavista B36XTCE Owners & Installation Manual

OPTIONAL WALL THERMOSTAT INSTALLATION

A wall thermostat may be installed if desired.
Recommended: The Wall Thermostat should be mounted beside the Re-
mote/Unit Receiver which comes standard with the appliance.
1. Run wires from thermostat into the unit.
2. Remove the green wire marked (TH) at the white connector-shown below.
The noted wires will be located near the gas valve.
Green Wires
Disconnect greenTH wire
3) Connect one thermostat lead to female connector, using male spade con-
nector - see picture below.
White Connector
4) Connect the other thermostat lead to male connector disconnected
from Step 1 using a female spade connector - see picture below.
When complete turn remote receiver to the <ON> position.
Unit will now operate using the wall thermostat.
NOTE: When the remote receiver is set to ON position, the re-
mote control transmitter and all of its features are now disabled.
CAUTION
Do not wire
Thermostat wires
to 120V wire.
Bellavista® B36XTCE-11 Gas Fireplace
installation
| 61