Section 2: Getting Started - Epilog Laser FusionPro 32 Original Instructions Manual

SECTION 2: GETTING STARTED

Setting up your Epilog Laser System is easy to do! If you've ever installed a paper printer, this is only
slightly more difficult. The following information will help you understand the entire system and how it
works.
Your Fusion Pro laser system consists of the following components:
1. Fusion Pro Laser System
2. Epilog Driver Disc
3. USB and Ethernet Cables
You will also need:
1. A computer or laptop.
2. An exhaust fan: The exhaust fan is mandatory and is used to remove smoke and debris from the
Fusion Pro work area. The exhaust air can be ported to the outside or into a filter box.
Follow these steps to setup your Fusion Pro Laser system:
1. Unpack the laser system.
2. Choose where to locate the system.
3. Connect the exhaust system to your laser.
4. Connect the electrical power.
5. Connect the laser to your computer through USB or Ethernet connection.
6. Sign up for driver updates and register your system at www.epiloglaser.com/register.
- 11 -