Table of Contents
Advertisement
Wake-Up On LAN (WOL)
Through the Wake-Up On LAN function, a wake event occurring from the network can
wake up the system. If this function is to be used, please be sure an ATX 2.01 power
supply of which 5VSB line is capable of delivering 720mA, and a LAN adapter which
supports this function is used. Then connect this header to the relevant connector on the
LAN adapter, set "Wake-Up by LAN/Ring" as Enabled in the "POWER MANAGEMENT
SETUP" section of the BIOS. Save and exit, then boot the operating system once to make
sure this function takes effect.
Wake-Up On Internal Modem (WOM)
Through this function, the system which is in the suspend or soft-off status can be
waked up by a ring signal received from the internal modem. When this function is used,
be sure an internal modem card which supports this function is used. Then connect this
header to the relevant connector on the modem card, set "Wake-Up by LAN/Ring" as
Enabled in the "Power Management Setup" section of the BIOS. Save and exit, then boot
the operating system once to make sure this function takes effect.
Sound Connector (PC-PCI)
This connector provides a bridge between the mainboard and PCI sound card to deliver
sound compatibility under DOS real-mode environment.
1
+5VSB
GND
Signal for waking up
+5VSB
1
Signal for waking up
GND
GND
PC-PCI DMA REQUEST
SERIAL INTERRUPT REQUEST
2 4 6
1 3 5
GND
NC
PC-PCI DMA ACKNOWLEDGE
Manual for SynactiX 5EP/5EI
Chapter 2
Advertisement
Table of Contents
