Table of Contents
Advertisement
Chapter 2
Chapter 2
Installation Instructions
Installation Instructions
This section covers External Connectors and Jumper Settings. Refer to the mainboard
layout chart for locations of all jumpers, external connectors, slots and I/O ports. Further-
more, this section lists all necessary connector pin assignments for your reference. The
particular state of the jumpers, connectors and ports are illustrated in the following fig-
ures. Before setting the jumpers or inserting these connectors, please pay attention to the
directions.
Be sure to unplug the AC power supply before adding or removing expansion
cards or other system peripherals, otherwise your mainboard and expansion
cards might be seriously damaged.
External Connectors
PS/2 Keyboard/Mouse Connector
PS/2 keyboard connector is for the usage of PS/2 keyboard. If using a standard AT size
keyboard, an adapter should be used to fit this connector. PS/2 mouse connector is for the
usage of PS/2 mouse.
PS/2 Mouse Connector
PS/2 Keyboard Connector
USB1, USB2 and LAN Connector (SynactiX 5EP-L/-AL, SynactiX 5EI-L/-
AL available)
Two USB ports are for connecting USB devices. The RJ-45 connector is for onboard LAN.
LAN(optional)
USB1
USB2
USB3, USB4
Two USB ports are not available on the back panel. Therefore, we provide a 10-pin cable
(optional) to connect on-board USB header and USB devices.
Active
LINK
+5V
D1-
D1+
GND
GND
Manual for SynactiX 5EP/5EI
Chapter 2
Optional
Optional
GND
GND
D0+
D0-
+5V
Advertisement
Table of Contents
