Infrared Header(Irda); Fan Connector(Cpu1~2Fan, Chsfan, Bfan); Wake-Up On Lan (Wol) - QDI GeniuX 1 Manual

Infrared Header (IRDA)
This connector supports wireless transmitting and receiving. You must set "Serial Port 2
Mode" to IrDA or ASKIR and configure the settings in the "INTEGRATED PERIPHERALS"
section of the BIOS.
VCC
IRRX
NC GND
IrDA
Fan Connector ( CPU1~2FAN, CHSFAN, BFAN)
The fan speed of these four fans can be detected and viewed in "System Monitor" section
of the BIOS.
Wake-Up On LAN ( WOL)
This connector is reserved for the usage of the customer' s own LAN card. Through Wake-
up On LAN function, a wake event occuring from network can wake up the system. If this
function is to be used, please be sure an ATX 2.01 power supply of which 5VSB line is
capable of delivering 720mA, and a LAN adapter which supports this function are used.
Then connect this header to the relevant connector on the LAN adapter, set "Resume by
Ring or LAN" as Enabled from the "POWER MANAGEMENT SETUP" section of the BIOS.
Save & exit, then boot the operating system once to make sure this function takes effect.
WOL
+5V standby
GND
Signal for waking up (active high)
IRTX
VCC
CHSFAN
CPU1FAN
CPU2FAN
BFAN
Manual for GeniuX 1
chapter 2
FAN GND
+12 V
SENSE
15