Table of Contents
Advertisement
Installation Instructions
Clear CMOS (JCC)
If you want to clear CMOS, unplug the AC power supply first, close JCC (pin1 & pin2)
once, set JCC back to the normal status with pin2 & pin3 connected, then power on the
system.
Enable/Disable onboard audio (JSD)
(SynactiX 5EP-A/-AL, SynactiX 5EI-A/-AL available)
If you want to use the on-board audio, set JSD with pin2 & pin3 closed (default). Other-
wise, set JSD with pin1 & pin2 closed for disabling this function.
Enable Front/Back Panel USB Device Wake-up Function (JFUSB/JUSB)
The mainboard provides the advanced USB device wake-up function. The system can be
waked up from its power saving including ACPI S3 by activating USB device. Before using
this function, set JFUSB/JUSB with pin1 & pin2 closed. Otherwise, set JFUSB/JUSB with
pin2 & pin3 closed for disabling. Furthermore, the item "Wake-Up From S3 by USB"in BIOS
setup should also be set corespondingly to enable or disable this function.
JFUSB
Normal status:
Clear CMOS:
(Unplug the AC power supply)
Enable on-board audio:
Disable on-board audio:
JUSB
Disable:
Enable:
Manual for SynactiX 5EP/5EI
JCC
1
2 3
JCC
1 2 3
1
JSD
2
3
1
JSD
2
3
JUSB
JFUSB
3
2
1 2 3
1
3
2
1 2 3
1
Advertisement
Table of Contents
