Table of Contents
Advertisement
BIOS Description
$"
First (Second,
Disabled
Floppy
Third) Boot Device
Boot Other Device
Swap Floppy
Enabled
$"
Drive
Disabled
Enabled
$"
Boot Up
Floppy Seek
Disabled
Boot Up
O n
$"
NumLock Status
Off
Normal
$"
Gate A20 Option
Fast
Typermatic Rate
Enabled
$"
Disabled
Setting
Typermatic Rate
6-30
$"
(chars/sec)
Typermatic Delay 250-1000
$"
(Msec)
Security Option
Setup
$"
System
OS Select For
Non-OS2
$"
DRAM>64MB
OS2
HDD S.M.A.R.T.
Enabled
$ "
Disabled
Capability
Report NO FDD
Yes
$"
for WIN 95
No
$"
Flash Write
Enabled
Disabled
Protect
Show Bootup
Enabled
$"
Logo
Disabled
Select Your Boot Device Priority. It could be
Disabled, Floppy, LS/ZIP, HDD-0, HDD-1, HDD-2,
HDD-3, SCSI, CDROM, LAN.
If the system has two floppy drives, choose
enable to assign physical drive B to logical drive
A and vice-versa.
Test floppy drives to determine whether they
have 40 or 80 tracks.
Select power on state for NumLock.
Let chipset control GateA20 and Normal - a pin
in the keyboard controller controls GateA20.
Default is Fast.
Keystrokes repeat at a rate determined by the
keyboard controller - when enabled, the typematic
rate and typematic delay can be selected.
The rate at which character repeats when you
hold down a key.
The delay before keystrokes begin to repeat.
Select whether the password is required every
time the system boot or only when you enter
setup.
Select OS2 only if you are running OS/2 operating
system with more than 64MB of RAM.
Enable hard disk S.M.A.R.T. support.
Invalidate this feature.
Report NO Floppy Disk Drive for WIN 95 to
release IRQ6.
Do not report No Floppy Disk Drive for WIN 95.
This option is for protecting the system BIOS,
when enabled, writing to BIOS area is to be
discarded.
The logo will be shown automatically when
system boots up, otherwise, no logo appears
on the screen.
Manual for SynactiX 5EP/5EI
Advertisement
Table of Contents
