Wake-Up On Lan (Wol); Wake-Up On Internal Modem (Wom) - QDI PlatiniX P8/333 Series Manual

Table of Contents

Installation Instruction

Installation Instr

uction

Wake-Up On LAN (WOL)

Through the Wake-Up On LAN function, a wake event occurring from the network can

wake up the system. If this function is to be used, please be sure an ATX12V power supply

and a LAN adapter which supports this function are used. Then connect this header to the

relevant connector on the LAN adapter, set "Power on by Ring/LAN" as Enabled in the

"POWER MANAGEMENT SETUP" section of the CMOS SETUP. Save and exit, then boot

the operating system once to make sure this function takes effect.

Through this function, the system which is in the suspend or soft-off status can be waked up

by a ring signal received from the internal modem. When this function is used, be sure an

internal modem card which supports this function is used. Then connect this header to the

relevant connector on the modem card, set "Power on by Ring/LAN" as Enabled in the

"Power Management Setup" section of the CMOS SETUP. Save and exit, then boot the

operating system once to make sure this function takes effect.

WOL

+5V standby

GND

Signal for waking up

WOM

+5V standby

Signal for waking up

GND

QDI

Table of Contents