Table of Contents
Advertisement
Fan Connector (CPUFAN, CHSFAN, BAKFAN)
The fan speeds of CPUFAN, CHSFAN and BAKFAN can be detected and viewed in "PC
Health" section of the BIOS.
Infrared Header (IrDA)
This connector supports Infrared transmitting and receiving. If using this function, set
"UART Mode Select" to IrDA or ASKIR and configure the settings from the "INTEGRATED
PERIPHERALS" section of the BIOS.
Wake-Up On LAN (WOL)
Through the Wake-Up On LAN function, a wake event occurring from the network can
wake up the system. If this function is to be used, please be sure an ATX 2.01 power supply
of which 5VSB line is capable of delivering 720mA, and a LAN adapter which supports this
function is used. Then connect this header to the relevant connector on the LAN adapter,
set "Wake up on LAN/Ring" as Enabled in the "POWER MANAGEMENT SETUP" section of
the BIOS. Save & exit, then boot the operating system once to make sure this function takes
effect.
Installation Instruction
CPUFAN
1
FAN GND
+12V
SENSE
1
BAKFAN
+12V
SENSE
FAN GND
1
CHSFAN
+12V
SENSE
FAN GND
VCC
NC
IRRX
GND
IRTX
VCC
1
+5VSB
GND
Signal for waking up (active high)
Manual for Advance 12 series
1
Advertisement
Table of Contents
