QDI SynactiX 5EP Manual page 57

Disabled
Enabled
$ IDE HDD Block
Mode
Disabled
KBC input clock 6/8 MHz
$
12/16 MHz
Button only
$ Power On
Function Password
KB Power ON Enter
$
Password
$ Onboard FDC Enabled
Disabled
Controller
Onboard 3F8/IRQ4,
$
Serial Port 1/2 2F8/IRQ3,
3E8/IRQ4,
2E8/IRQ3,
Auto
Disabled
UART Mode Select Normal, IrDA
$
ASKIR
Hi, Lo/Lo, Hi
$ RxD, TxD Active
Lo, Lo/ Hi, Hi
IR Transmission Enabled
$
Delay Disabled
Onboard Parallel 378/IRQ7
$
Port 278/IRQ5
3BC/IRQ7
Disabled
Parallel Port Mode SPP,EPP ,ECP Define the parallel port mode
$
ECP+EPP
"""""""""""""
$ EPP Mode Select EPP1.7/EPP1.9 Set EPP Mode is EPP 1.7 Version or is 1.9 Version
3
$ ECP Mode Use
DMA 1
PWRON After OFF,ON
$
PWR-Fail Former-Sts
Game Port Disabled
$
201,209
Address
Midi Port Address Disabled
$"
300,330,290
Midi Port IRQ 5
$ "
10
CNR Interface is disabled.
Allow IDE HDD to read/write several sectors at
once.
IDE HDD only reads/writes a sector once.
Set the PS/2 Keyboard input clock as 6/8/12
/16MHz.
Power on by power button
Power on with keyboard password
Enter keyboard password
Onboard floppy disk controller is enabled.
Onboard floppy disk controller is disabled.
Define the onboard serial port address and
required interrupt number.
Onboard serial port address and IRQ are
automatically assigned.
Onboard serial port is disabled.
Set UART mode
Default is recommended
Enable IR Transmission delay Function.
Disable IR Transmission delay Function.
Define parallel port address and IRQ channel.
Onboard parallel port is disabled.
Set ECP Mode Use DMA is 1 or 3.
The system remains OFF/ON/Former state when
the AC power supply resumes.
This option is used to configure Game Port
Address.
This option is used to configure Midi Port
Address.
This option is used to configure Midi Port
IRQ.
Manual for SynactiX 5EP/5EI
Chapter 3