Mitsubishi Electric MELSEC-A0J2H Series Handbook page 199

Specifications
5VDC internal current
105mA (TYP. All points are ON.)
consumption
External
supply Voltage
power
(Module
power
Current
supply)
External connection 36-point terminal block connector
method
Applicable wire size
(Applicable tightening torque 69N•cm)
1.25-3, 1.25-YS3A, 2-S3,
Applicable solderless
2-YS3A, V1.25-3, V1.25-YS3A,
terminal
V2-S3, V2-YS3A
Weight
External dimensions 250(H) × 132(W) × 41(D)mm
*1 The figure below shows the derating chart.
When the voltage of the external supply power (module power supply) is high, the rate of AC input simultaneous ON
becomes small.
*2 Check that the specifications of leakage current of the used sensor and switches are equal to or less than the OFF current
value.
If leakage current is equal to or more than the OFF current specifications, take measures against it with referring to "Input
Module Troubleshooting" in the following handbook.
(Handbook for replacement)
Renewal tool for A0J2 series Transition from MELSEC-A0J2(H) series to renewal system using renewal tool.
*3 The value when using the input module QX41, etc. and 1ms is set at input response time in I/O assignment setting of PLC
parameter (10ms is set at default).
*4 The weight of fixed stand of programmable controller depends on replacement type of renewal tool for A0J2.
*5 The external dimensions of the SC-A0JQIF32A do not include those of its projection.
A0J2-E32A
None
Ripple voltage 4Vp-p or less
None
36-point terminal block connector
(M3 × 6 screws)
2
0.75 to 2mm
(Applicable tightening torque 69N•cm)
1.25-3, 1.25-YS3A, 2-S3,
2-YS3A, V1.25-3, V1.25-YS3A,
0.68kg
182(H) × 132(W) × 41(D)mm
(%)
100
90
80
Simultaneous ON
70
ratio at AC input
60
50
40
30 40
Ambient temperature
: Compatible,
SC-A0JQIF32A Compatibility
– –
24VDC±10%
×
210mA ×
(M3 × 6 screws)
2
0.75 to 2mm
V2-S3, V2-YS3A
0.40kg
*5
×
26.4VDC
External power supply
(module power supply)
50 55 (­)
: Partially changed, × : Incompatible.
Precautions for replacement
To deliver a power for programmable
controller operation, connecting a
module power supply to the interface
module, TB35 or TB36 is required.
If the voltage exceeds existing power
capacity, add 24VDC power supply
separately.
Also consider the weight of fixed stand
*4
of programmable controller.
Check the dimensions since they
depend on the installation type
(building-up/horizontal/separate type).
App
- 4