Table of Contents
Advertisement
c)
Depress
DATA LOGGER
a)
The DATA LOGGER uses the communications strings to pass data out through
the serial port. The data is sent at a set time interval or a set distance
traveled, as determined by the values entered in the DATA LOGGER TRIGGER
VALUE and DATA LOGGER TRIGGER UNITS.
string, Data Strings 1, 2, 3, 4, and 5, and the Time/date string are sent,
in that order.
will automatically send out the Cal 1, 2, and 3 strings.
switch is changed, the Data 1, 2, 3, 4, 5, Time/Date, and Cal 1, 2, 3, strings
will be sent by the Console.
and Cal strings can also be requested by the data logger using the request
strings.
b)
LIQ display will show "SPr". Left DATA display will show "dLoG". Right
DATA display will show "oFF".
c)
Depressing
value of "oFF" means DATA LOGGER is disabled; a value of "on" means DATA
LOGGER is enabled.
d)
Depress
e)
Depress
GLOBAL POSITIONING SYSTEM SCREENS
GPS SYSTEM OPTIONS
a)
GPS is inactive when the LIQ display shows "GPS", the left DATA display
shows "SYSt", and the right DATA display shows "inAC".
be in this mode if connected to a temperature sensor and not connected to
a GPS system.
b)
Depress
ALARM SCREENS
AUDIBLE ALARM
The DCS 410 has several alarm indicators.
to acccommodate the operators preference.
a)
LIQ display will show "ALr".
DATA display will show "on".
to advance to DATA LOGGER.
When a Console calibration value is changed, the Console
The Data, (with Time/Date string included)
steps the right DATA display between "oFF" and "on". A
to advance to CONSOLE DATA PRINTOUT.
to advance to the GLOBAL POSITIONING SYSTEM SCREENS.
to advance to the ALARM SCREENS.
Left DATA display will show "ALrM".
22
Upon each trigger, the Actual Rate
The alarms can be turned on or off
When a Console
The console must
Right
Advertisement
Table of Contents
