Menu Elements Reference - Wilo Yonos GIGA-N 80 Installation And Operating Instructions Manual

8.6.8 Activating/deactivating termina-
tion
8.7

Menu elements reference

No. Designation
Setpoint
1.0.0.0
Control mode
2.0.0.0
Installation and operating instructions Wilo-Yonos GIGA-N
Operation
ƒ
To confirm the change, press the operating button.
Current status of disable function:
ƒ
Disable active
No changes can be made to setpoints or settings. Read-only access to all menu ele-
ments is maintained.
ƒ
Disable inactive: the elements of the basic menu can be edited (menu ele-
ments <1.0.0.0>, <2.0.0.0> and <3.0.0.0>).
NOTICE
To edit the sub-elements of menu <5.0.0.0>, service mode must also be activated.
ON
ƒ
Reset DIP switch 2 to the "OFF" position.
2
The display returns to the status page.
NOTICE
Errors can be acknowledged after a waiting period despite the "access disable" being
active.
In order to establish a definite communication connection between two electronic
modules, it is necessary to terminate both ends of the cable.
To activate or deactivate:
ON
ƒ
Set DIP switches 3 and 4 to the "ON" position.
X
Termination is activated.
NOTICE
Both DIP switches must always be in the same position.
ON
ƒ
To deactivate, return the DIP switch to the starting position.
X
This chapter gives an overview of all elements at all menu levels. The menu number and
the element type are designated separately, and the function of each element is ex-
plained. If applicable, there is information about the settings options of the individual
elements.
NOTICE
In certain situations, some elements are hidden. These are therefore skipped in the
navigation of the menu.
Example: If the external setpoint adjustment under menu <5.4.1.0> is set to "OFF",
menu number <5.4.2.0> will be hidden. Menu number <5.4.2.0> is only visible if the
external setpoint adjustment in menu <5.4.1.0> is set to "ON".
Type Symbol Values/explanations
Setting/display of setpoint
±
(for additional information, see "Adjusting
the setpoint" chapter)
Setting/display of control mode (for addi-
±
tional information see "Control modes"
and "Setting the control mode" chapters)
Display conditions
en
47