Wilo Yonos GIGA-N 80 Installation And Operating Instructions Manual page 73

12.3.2 Error type B
5
8
Fig. 66: Error type B, flowchart
Incidence X < Y
6.0.0.0
E000
6.0.0.0
75
3/6 S
Fig. 67: Acknowledging error type B (X < Y)
Incidence X = Y
Installation and operating instructions Wilo-Yonos GIGA-N
Faults, causes and remedies
Program step/query
1
1
2
2
3
3
4
5
4
6
7
8
6
Table 29: Error type B
Acknowledging error type B:
7
ƒ
To change to menu mode, press the operating button. Menu number <6.0.0.0>
flashes on the display.
ƒ
Press the operating button again. Menu number <6.0.0.0> is displayed without
flashing.
The units display shows the current incidence (x) as well as the maximum incidence of
the error (y) in the format "x/y".
If the current incidence of the error is less than the maximum incidence:
ƒ
Wait for auto reset time.
The value display shows the remaining time until auto reset of the error in seconds.
After the auto reset time has run out, the error will be automatically acknowledged and
the status page will be displayed.
12.3
NOTICE
The auto reset time can be set in menu number <5.6.3.0> (time input 10 to
300 seconds).
If the current incidence of the error is equal to the maximum incidence:
ƒ
Wait until the remaining time is up.
The time until manual acknowledgement is always 300 seconds. On the value display,
the remaining time until manual acknowledgement of the error is displayed in seconds.
ƒ
Press the operating button again. The error is acknowledged, and the status page is
displayed.
Contents
ƒ
Error code is displayed
ƒ
Motor Off
ƒ
Red LED On
ƒ
Error counter is increased
Error counter > 5?
ƒ
SSM is activated
> 5 min?
> 5 min?
Error acknowledged?
End; auto control resumes
Yes
No
en
73