Table of Contents
Advertisement
en
No.
Designation
Δp-v gradient
2.3.2.0
Pump on/off
3.0.0.0
Information
4.0.0.0
Actual values
4.1.0.0
Actual values
4.1.1.0
sensor (In1)
Power
4.1.3.0
Operating data
4.2.0.0
Operating hours
4.2.1.0
Consumption
4.2.2.0
Pump cycling
countdown
4.2.3.0
Remaining time
until pump kick
4.2.4.0
"Mains on"
counter
4.2.5.0
Pump kick
4.2.6.0
counter
Statuses
4.3.0.0
Base-load pump
4.3.1.0
SSM
4.3.2.0
48
Operation
Type Symbol
Values/explanations
Constant speed control
Constant Δp-c control
PID-Control
Setting gradient of Δp-v (value in %)
ON
±
Pump switched on
OFF Pump switched off
Information menus
Display of current actual values
Depending on current control mode.
Δp-c, Δp-v: Value H in m
PID-Control: Value in %
Current power input P
Display of operating data
The pump's total active operating hours
(counter can be reset via infrared inter-
face)
Energy consumption in kWh/MWh
Time to pump cycling in hours (at a resolu-
tion of 0.1 h)
Time until the next pump kick (after the
pump has had a 24-hour standstill, e.g. via
"External off", it will be automatically op-
erated for 5 seconds)
Number of times the supply voltage is
switched on (each occasion the supply
voltage is established after an interruption
is counted)
Number of pump kicks carried out
The value display shows the identity of the
regular base-load pump statically. The
units display shows the identity of the
temporary base-load pump statically.
ON
Status of SSM relay if a fault message is
present
Display conditions
Not displayed for all pump types
Not displayed for constant speed
in W
1
The operating data refer to the
electronic module currently being
operated
Shown only for twin-head pump
master and internal pump cycling.
Can be set in the service menu
<5.1.3.0>
Only displayed if pump kick is ac-
tivated
Only displayed if pump kick is ac-
tivated
Only displayed for twin-head pump
master
WILO SE 2020-10
Advertisement
Table of Contents
